Universal Remote Control URC-200 Owner's Manual download pdf (Page 7)

The Search Method

If your device does not respond to the ONE FOR ALL 3 after you have tried

all the codes listed for your brand, try searching for your code. The Search

Method allows you to find the code for your device by scanning through all

the codes contained in the memory of the ONE FOR ALL 3. The Search

Method may also work if your brand is not listed at all.

Example: To search for your TV code:

1 Switch your television on (not on standby) and aim your

ONE FOR ALL at your TV.

2 Press the TV key on your ONE FOR ALL 3.

3 Press and hold down MAGIC until the ONE FOR ALL 3’s

red light blinks twice (The red light will blink once and

then twice).

4 Press 9 9 1. The red light will blink twice.

5 Now slowly, alternate between TV and POWER, over and

over, until your television turns off. You may have to

press these keys many times (up to 200!), so please

be patient. Remember to keep pointing the ONE FOR

ALL 3 at your television when you press these keys.

6 As soon as your television turns off, press MAGIC.

The ONE FOR ALL remote should now be ready to operate your device.

Turn your device back on and try all the remote’s functions to ensure they

are working properly. If some of the ONE FOR ALL’s commands are not

operating correctly, try the search method again. You may be using the

wrong code.

Once you have Set-Up your ONE FOR ALL 3, you can blink back your

SET-UP CODE for future reference.

Example: To blink out your Television code:

1 Press TV once.

2 Press and hold MAGIC until the ONE FOR ALL 3’s TV key

blinks twice (The red light will blink once and then twice).

3 Press 9 9 0. The red light will blink twice.

4 For the first digit of your four-digit code, press 1 and

count all the red blinks. If there are no blinks, the digit is

"0".

5 For the second digit, press 2 and count all the red blinks.

If there are no blinks, the digit is "0".

6 For the third digit, press 3 and count all the red blinks.

If there are no blinks, the digit is "0".

7 For the fourth digit, press 4 and count

all the red blinks. If there are no blinks, the digit is "0".

Now you have your four-digit code.

Make sure you write your Television code in the boxes provided in

the battery compartment and on page 8 for easy future reference.

Important notes:

- To search for the code for another device follow the instructions above

only press the appropriate device key instead of TV during steps 2 and 5.

- If the original remote control of your VCR does not have a POWER key,

press PLAY instead of POWER during step 5.

Important note: To blink back the code for your other devices press the

appropriate device key during step 1.

WWW.ONEFORALL.COM 7

1 2 3 4 5 6 7 8 9 10 11 12 ... 20 21

Comments to this Manuals

No comments

Universal Remote Control URC-200 Owner's Manual Page 7

Comments to this Manuals

Related products and manuals for Remote controls Universal Remote Control URC-200