Universal Remote Control URC-SR3 User Manual download pdf (Page 15)

Page 15

STEP 2: Press the component button you want to

turn on and then the POWER button; repeat for all

other components in the order you want them to

turn on. The component LED lights will blink once

each time you press the POWER button.

STEP 3: Once you’ve entered all the Power On

commands, press the CHANNEL UP button to save

your MacroPower commands. The component LED

lights will blink two times to confirm that the

programming has been successfully saved.

SUGGESTION: Most of the components have the

same signal to turn the power On and Off. You

may want to program MacroPower only in the

POWER button and save the System Off button to

turn components On or Off individually.

Note: If you want to program MacroPower for the

ALL OFF button, repeat the same steps used for

Power ON programming.

Notes regarding programming multi-

commands to Macro buttons:

• You can program up to 20 commands on each

Macro button.

• You can program delays in between commands

by pressing the PAUSE button. Each press adds

a one-half second delay.

• Also, if you add the delay time as the first step

of Macro commands, the remote will not send

the Macro unless the button is held for two

seconds. (This is the Press & Hold Function).

• You can also program macro commands in

‘layers’ by pressing the STOP button in between

commands. (For example, if you press CBL,

009, STOP, 035, STOP, 365, STOP and the

CH+ button in Step 2) the remote will send out

009 at the first press of the ‘A’ button, and then

send out 035 at the second press, etc.

• You cannot program the CH+ or PAUSE buttons

as macro commands.

POWER

COMPONENT

BUTTONS



1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 43 44

Comments to this Manuals

No comments

Universal Remote Control URC-SR3 User Manual Page 15

Comments to this Manuals

Related products and manuals for Remote controls Universal Remote Control URC-SR3