Universal Remote Control URC-300 Specifications download pdf (Page 7)

Y1-03-0232G 6

Surface Mount

Install the surface mount Point Pad™ by drilling

three (3) holes in the dashboard location using

the Point Pad™ Surface Mount Template

supplied in the Mounting Templates. Mount the

Point Pad to the dashboard using the gasket,

washers and nuts supplied. Apply a sealant

around the bolt holes to protect from moisture

intrusion.

Flush Mount

When the flush mount is selected, cut a

rectangular hole in the dashboard location using

the Point Pad™ Flush Mount Template supplied in

the Mounting Templates. Use the gasket, washers,

nuts and the two U-Clamps provided to secure the

Point Pad™. Apply a sealant around the cut out to

protect from moisture intrusion.

Connecting to the Master Controller

The Point Pad™ communicates with the Master Controller via standard

television type RG-59 coaxial cable. The connectors are standard “F”

type television connectors. The connector on the back of the Point

Pad™ is located in the center of the panel for ease of installation. After

the coax cable has been routed and the “F” connector is attached to the

coax cable, screw the “F” connectors to the Master Controller and the

Point Pad™.

Additional Point Pads™ (up to three) may be used with one (1) Master

Controller. A standard “T” connector or RG-59 television type splitter is

used for each additional Point Pad™. Limit the total length of all coax

cable used to 300 feet.

URP-102

Surface Mount

URP-102

Flush Mount

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

No comments

Universal Remote Control URC-300 Specifications Page 7