Universal Remote Control MRX-10 Installation Manual download pdf (Page 11)

Page 8

trol voltage out of the current sensor to the two-pin plug-in con-

nector on the VS-1006. The VS-1006 can sense AC or DC so

polarity is not critical.

3. Connect the 4-circuit mini plug from the VS-1006 to the sensor

input on the MRX-1 rear panel.

4. Plug the power cord on the current sensing device into an

unswitched AC outlet.

5. Once the system has been powered up, the VS-1006 Power LED

should illuminate Red.

6. To test Voltage Sensing, turn the Sensed Device on. The Sensor

LED on the MRX-1 front panel should illuminate in blue. Turn

the Sensed Device off and the LED should turn off as well. If not,

check the connections and measure the device control out with a

volt meter to confirm voltage output. Also confirm that the

Sensed Device’s Power Cord is connected to a Sensed Outlet.

VID-6 Video Sensor Cable

The Video Sensor Cable VID-6 is a special cable for sensing com-

posite video. When composite video is detected, the MRX-1 recog-

nizes that the connected device is ON. System Power ON/OFF

macros, conditional IF/ELSE Smart Macros and other control modes

are typically associated with the status of these sensor inputs. When

an ON condition is detected at the sensor input, the corresponding

Front Panel Sensor LED will illuminate in blue to indicate the ON

condition. Not all devices turn the composite video output off when

in standby, some switch to a black screen. A black screen looks off

and protects some types of video displays from ‘burn in’, but there

is still a sync code present that is not compatible with video sensing

for ON/OFF status. For devices that output a black screen, use a

Voltage Power Sensor from a switched outlet (or status output on the

device if available), a sensed AC outlet that outputs 12V or discrete

IR ON/OFF codes or RS-232 commands.

Connection

Composite

Video (VID-6 Video Sensor Cable)

1. Connect the MALE end of a single male to two female RCA plug

‘Y’ Adapter to the Composite Video Out on the device to be

sensed.

2. Connect the RCA Plug end of the VID-6 Sensor Cable to one of

the jacks on the Y Adapter.

3. Connect the 4-circuit mini plug end of the VID-6 cable to the

Sensor input on the MRX-1 Rear panel.

4. Connect the Second Jack on the Y adapter to the appropriate

MRX-1 BASE STATION

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 26 27

Comments to this Manuals

No comments

Universal Remote Control MRX-10 Installation Manual Page 11

Comments to this Manuals

Related products and manuals for Networking Universal Remote Control MRX-10