Universal Remote Control MRX-10 Installation Manual download pdf (Page 24)

Page 21

MRX-1 BASE STATION

Frequently Asked Questions

Can I use flasher/emitters that I have already installed in the sys-

tem to connect to the MRX-1?

Yes, the flashers are compatible if they use 3.5mm mono mini plugs

with the same polarity (Tip is data, sleeve is ground). It is important

to notate the RFTX-1 shared port utilizes a sleeved emitter for long

term use.

I’m getting inconsistent operation regardless of flasher level or

position.

Some components are easily overloaded with IR from nearby flash-

ers. Prevent IR from affecting the problem component from other

flashers by setting the device to a specific IR Line Output instead of

ALL, then adjust the Line Output.

I am unable to control my URC Lighting Dimmer/Switch with the

MRX-1. Now what?

Make sure the RF switch on the RFTX-1 is set to the correct fre-

quency for the URC Dimmer or Switch. URC Lighting Models

MRFA is 418MHz and MRFB is 433MHz.

How do I update the firmware?

Make sure the MRX-1 is connected to the Network then open CCP

and click on the Firmware button located

How can I set my MRX-1 to factory default?

Look on the bottom of the MRX-1 and remove the cover plate to

reveal a reset button. Reboot the unit by pressing the reset button

once or press and hold for three seconds to factory default the unit.

Specifications

Network: One 10/100 Ethernet port

Relay: One relay configurable to be NO, NC or Momentary

Sensor: One sensor supports Video or Voltage sensing via URC sen-

sors.

RS-232: Two RS-232 ports support TX, RX and GND two way com-

munication via URC cables.

IR: Six adjustable IR ports enable the included URC emitters to

control IR devices Note: 6th IR Output requires the included

sleeved emitter (identified by a pink connector), since it can option-

ally be used to connect an RFTX-1

Weight: 8.4 oz.

Size: 248 x 120mm x28mm

Power: 12v External Power Supply

1 2 ... 19 20 21 22 23 24 25 26 27

No comments

Universal Remote Control MRX-10 Installation Manual Page 24