Universal Remote Control URC-4041 User Manual download pdf (Page 24)

URC PLUS User’s Guide



Appendix B – Other Features

Showing URC PLUS Firmware Version

The URC PLUS firmware version is in the format of x.y.z, where x, y and z is digit 0-9. Use the following

procedures to show the URC PLUS firmware version:

1. Press “STB”.

2. Press and hold “SETUP” for 5 seconds.

3. The “STB” backlight will illuminate.

4. Press “INFO” once.

5. The 3 digits of the firmware version (x, y and z as described above) will be displayed in the following

manner.

a. The “STB” backlight blinks to indicate the digit. One blink indicates 1, 2 blinks indicates 2, etc

until 9 blinks indicates 9. A 0 is indicates by a shot, long, short, long, short, long blink.

b. In between each digit, the “STB” backlight will be off for 1 second.

c. For example, the following blink pattern shows a firmware version of 2.0.4.

. . .-.-.- ....

Showing Programmed Device Code

You can display the 4-digit device code by the following procedures:

1. Press “TV” to display the TV device code or “AUX” to display the AUX device code.

2. Press and hold “SETUP” for 5 seconds.

3. The “TV” or “AUX” backlight will illuminate.

4. Press “INFO” once.

5. The 4-digits device code will be displayed in the following manner.

a. The “TV”/”AUX” backlight blinks to indicate the digit. One blink indicates 1, 2 blinks indicates 2,

etc until 9 blinks indicates 9. A 0 is indicates by a shot, long, short, long, short, long blink.

b. In between each digit, the “TV”/”AUX” backlight will be off for 1 second.

c. For example, the following blink pattern shows a device code of 0123.

.-.-.- . .. ...

Factory Reset

You can factory reset the remote by pressing the “SETUP” and “POWER” button at the same time for 10

seconds. After factory reset, the programmed device setting will lose. You need to program the devices and

do the remote registration with your Hydra/Amulet again. In case, you find your remote does not function as

expected, you can also try the factory reset.

1 2 ... 19 20 21 22 23 24

No comments

Universal Remote Control URC-4041 User Manual Page 24