Universal Remote Control Thermo Control Instruction Manual download pdf (Page 62)

Sunis sensor should be mounted in or near window and

exposed to incoming light.

QUICK PROGRAMMING FOR SUNIS INDOOR WIREFREE SENSOR

Setting the Light (Sun) Sensitivity (Threshold)

STEP 1: Refer to previous “Setting the Light (Sun) Sensitivity Threshold”

instructions.

STEP 2: Sunis light sensor will send a DOWN COMMAND to the RTS receiver or

motor after 5 minutes of sensing light within the set threshold.

STEP 3: Sunis RTS light sensor will send an UP COMMAND to the RTS receiver

or motor after 30 Minutes of sensing light that HAS FALLEN BELOW THE SET

THRESHOLD.

GREEN LED: INDICATES SUN (Light) WITHIN THRESHOLD SETTING

RED LED: INDICATES SUN (LIGHT) BELOW THRESHOLD SETTING

OPERATING MODE

STEP 3: Momentarily press the MODE BUTTON. LED Indicator will illuminate for

approximately 15 seconds.

LED Indicator light will remain illuminated for approximately 15

seconds. Should the LED Indicator light extinguish prior to establishing

the light sensitivity (threshold) setting, simply press the MODE BUTTON

momentarily to reactivate LED light.

STEP 4: Using a small screw driver or similar device, rotate the Sun Sensitivity

Selector to the fully CLOCKWISE (+) position. LED Indicator light will illuminate

red (See Figure 3 pg. 62).

STEP 5: Slowly rotate the Sun Sensitivity Selector COUNTER CLOCKWISE (-) until

the LED Indicator illuminates to a green color. A green colored LED indicates the

present light value (threshold). At this value (threshold) the Sunis sensor will

provide the necessary DOWN COMMAND to the motorized window covering.

Default employs output response time delays.

STEP 1: Carefully remove rear cover of Sunis Light sensor exposing control

setting panel.

STEP 2: Slide the ON/OFF Selector Switch to the ON or position.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 92 93

No comments

Universal Remote Control Thermo Control Instruction Manual Page 62