Universal Remote Control URC-4041 User Manual download pdf (Page 15)

URC PLUS User’s Guide



To Program a TV or AUX device

1. Locate the device code for your desired device in the device code table provided in the Appendix. If you

could not find the device code for your device or it does not work after trying the listed device codes for

your device brand, then you can go to the next section to try the auto search procedures.

2. Turn on your device and with media inserted (if applicable).

3. On the remote control, press a device mode key once (i.e., “TV” or “AUX”).

Figure 4-2 Select the device mode

NOTE: Use the “AUX” mode key to program control of VCR, DVD player, cable box, satellite set-top-

box and audio device.

4. Press and hold the “Setup” key until the selected mode key backlight blinks twice, then release “Setup”.

The device mode key will light up.

Figure 4-3 Press SETUP for 5 seconds to enter device setup mode

5. Enter the four-digit device code for you device. If you perform this procedure correctly, the selected

device mode key backlight will blink twice.

NOTE: If you enter an invalid device code, the selected device mode key will fast blink 7 times. Device

program mode will be terminated.

6. Aim the remote control at your device and press the “Power” once. The device should be turn off. If it

does not respond, repeat the above steps.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

No comments

Universal Remote Control URC-4041 User Manual Page 15