Universal Remote Control Titan M2056-C Owner's Manual download pdf (Page 23)

Using the Remote Control

Continue pressing PLAY unlil llle component turns off or llle indicator lighl

on llle remote turns oft'. If llle indicator light turns off, then all codes for that

particular component have been tested once. If the component does not turn

off', dmn the remote can't be progrm:qmed to operate dlat component.

If llle component you want to control does turn off:

1. Press and release REVERSE, then wait 2 seconds. Repeat this step until the

device turns back ON.

2. To finish, press and hold STOP until the indicator on tile remote turns off.

A code that controls your component has been saved to that remote button.

Important

You must continue pressing the component

button while you enter the code.

Let's say you have a Zenith DVD playe_ To

program the universal remote to operate the

DVD player, you would:

Press and hold the DVD button while you

enter the first code listed for Zenith in the

DVD Codes column.

Release the DVD button. Press ON*OFF to

see if the DVD player responds. If it doesn't,

follow the same steps, but enter the second

code for Zenith DVD players instead of the

first.

Using Direct Entry

1. Turn on the component to be programmed.

2. Look up the brand and code nm:qber(s) for the co_:qponent on the code list

in this section.

3. Press and hold the component button you want to program on the remote.

4. Enter llle code from the remote control code list on llle following pages. If

dm indicator flashes, you have either entered an invalid code or the button

isn't programmable.

5. Release the component buuon, point the remote at the component and

dmn press ON*OFF to see if tile component responds to tile command. If it

doesn't, try pressing tile component button and dmn ON* OFF again.

* If you get no response, repeat these steps using llle next code listed for

your brand, until llle component responds to the remote commands.

* If you fry all the codes tbr your component brand and none work, try tile

automatic code search method. If automatic code search doesn't find the

code, the remote is not compatible with your component.

Chapter 2 Graphics contained within this publication are fi)r representation on/y. 21

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 47 48

No comments

Universal Remote Control Titan M2056-C Owner's Manual Page 23