Universal Remote Control Titan M2056-C Owner's Manual download pdf (Page 6)

¢onn ctiQns Setup

Things to Consider Before You Connect

Protect Against Power Surges

• Connect all components before you plug any" of their power cords into the wall outlet.

• Turn ot_"lhe TV and/or component before you connect or disconnect any cables.

• Make sure all antennas and cables are properly grounded. Refer to the hnportant Safety

Instructions on page 1.

Protect Components from Overheating

• I)on't block ventilation holes on any of the components. An'ange the components so that air

can circulate freely.

• Don't stack components.

• If you place components in a stand, _:qake sure you allow adequate ventilation.

• If you connect an audio receiver or amplifier, place it on file top shelf so file heated air from it

won't flow around other components.

Position Cables Properly to Avoid Audio Interference

• Insert each cable firmly into the designated jack.

• If you place components above the TV, route all cables down the side of the back of the TV

instead of slraight down the middle of the TV.

• If your antenna uses 300-ohm twin lead cables, do not coil the cables. Also, keep the twin

lead cables away from audio/video cables.

Important Stand and Base Safety Information

Choose the location for your "IV carefully. Place the TV on a stand or base that is of adequate size

and strength to prevent the TV from being accidentally tipped over, pushed off, or pulled off. This

could cause personal iniury and/or damage the TV. Ret_:r to the Important Safety lnslructions on

page 1.

Use Indirect Light

I)on't place the TV where sunlight or room lighting will be directed toward the screen. Use sofi or

indirect lighting.

4 Graphics contained within lhispublication ar_fi)r r_presentation only. Chapter 1

1 2 3 4 5 6 7 8 9 10 11 ... 47 48

No comments

Universal Remote Control Titan M2056-C Owner's Manual Page 6