Universal Remote Control URC-SR3 Owner's Manual download pdf (Page 10)

Page | 9

1. Quick Set-up

Set-up one component at a time, and you’ll

move quickly through your system.

Step 1:

Turn on the component you want to

activate. (Other components can be on or

off, it doesn’t matter.)

Step 2:

Point your new URC-SR3 Remote

Control toward the component and press the

appropriately labeled Component button (TV

for TV, DVD for DVD, etc.) While holding this

button down, press the numeric assigned to

your brand in the Quick Set-up Code Table

(See Page 2) and release both Component

button and the number key to save the code.

The component light will blink two times to

confirm that the code has been stored.

Step 3:

Point the remote control at the

component.

Step 4:

Press the power button. If it turns

off, it is programmed for your component. If

it does not turn off, use the Pre-Programmed

3-Digit code Method or Scanning Method.

Check your work. Press the POWER [ON]

button to turn the component back on.

Next, test the VOLUME and CHANNEL buttons

(or PLAY and STOP buttons for DVD) to make

sure they all work. Repeat steps one through

three until all your components are set up prop-

erly.

COMPONENT

BUTTONS

NUMBER

PAD

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 51 52

Comments to this Manuals

No comments