Universal Remote Control URC-SR3 Owner's Manual download pdf (Page 13)

3. Auto-Search Set-up

The Auto-Search Set-up scans through all of

the codes in the table to find the right code

for your component. Use this method for

components you cannot set up with either

the Quick Set-Up or 3-Digit Set-up. This

step is not difficult, but tests your patience,

as it takes about five minutes to work through

the entire table.

STEP 1: Turn on the component you want to

activate. (Other components can be on or

off, it doesn’t matter.)

STEP 2: On the URC-SR3, press the

Component button that you want to set up

and the SELECT [SEL] button at the same

time. Hold down both buttons for two

seconds until the Component button light

turns on. This signals that you are in set-up

mode and can release the buttons.

STEP 3: Point the remote control toward the

component and press the UP or the DOWN

arrow button on the nav igation pad. Each

time the UP or DOWN arrow button is

pressed, the code will count up (or down)

one code number and send a Power OFF

signal to the component.

Page | 12

COMPONENT

BUTTONS

SELECT

BUTTON

DOWN

6

ARROW

UP

5

ARROW

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 51 52

Comments to this Manuals

No comments