Universal Remote Control URC-SR3 Owner's Manual download pdf (Page 29)

Erasing Commands - Overview

If you have set up your macros and punch

throughs, you should be able to put all your

other controls away for safe keeping.

However, you may find one pesky control you

want to change or get rid of. The URC- SR3

allows you to erase commands easily.

You can erase a single learned command, all

learned commands in each omponent mode,

SimpleSound programming, MacroPower

commands, or re—set the remote to original

factory default settings.

These next few pages walk you through the

process.

Erasing a Single Learned Command

from One Component

STEP 1: Press the component button where

the learned command is stored and the [ENTER]

button at the same time for two seconds until the

component LED light turns on.

STEP 2: Press and hold the button you want

to erase for two seconds. The component light

will blink twice to confirm the erasure.

NOTE: If you do not press a button within 30

seconds, the component light will turn off. The

remote will exit the programming mode, and

you will have to start over with step one.

STEP 3: Repeat Step 2 to erase any other

buttons in the selected component mode.

STEP 4: To exit Erase mode, press and hold

both the component button and the [ENTER]

button at the same time until the component

light blinks three times.

Page | 28

ENTER

COMPONENT

BUTTONS

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 51 52

No comments

Universal Remote Control URC-SR3 Owner's Manual Page 29