Universal Remote Control Titan M2056-C Owner's Manual download pdf (Page 13)

Connections Setup

TV + DVD + VCR

1. Connect your DVD Player to your TV.

A. Connect the audio (white and red) cables to the CMP1 L and R Audio jacks on the back of

tim TV and to the Audio Output iacks on the DVD player.

B. Connect three video grade cables to the CMP1 Y PB PR iacks on the back of the TV and to

llle Y PB PR jacks on the DVD player.

Notes:

If your DVDplayer does not have YPBPRjacks, but does have an S-Videojack, connect the

player to the VID1S-VIDEOjack on the TV using an S-Video cable.

If your DVD player does not have an S-Videojack, connect the player to the VID1 V (Video)

jack on the back of the TV using a video cable.

Important: If you use the VIDI S-VIDEOor V (Video)jack to connect your TV to the DVD

player, you must connect the audio cables to the VIDI L/MONO and Rjacks on the T_

2. Connect your VCR to your TV.

A. Connect a coaxial cable to the VCR's antenna output and to the ANTENNA/CABLE Input

jack on the TV.

B. Connect the audio (white and red) cables to the VID2 L/MONO and R Audio iacks on the

back of the TV and to the Audio Output iacks on the VCR.

C. Connect the video cable to the VID2 V (Video) iack on the back of the TV and to the Video

Output jack on the VCR.

3. Make sure cable or antenna is connected to your VCR.

Connect the coaxial cable from your cable outlet or antenna to tim antenna input on the VCR.

Go to page 15

Chapter 1 Graphics contained within this publication are fi)r representation only. 11

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 47 48

No comments

Universal Remote Control Titan M2056-C Owner's Manual Page 13